U.S. Senators Urge FAA to Pause New Router Deployment Pending Testing
Democratic lawmakers on November 17 urged the Federal Aviation Administration to immediately pause deployment of additional Juniper routers pending further testing after a nationwide ground stop last week led to the cancellation of more than 18,000 flights.
Transportation Secretary Sean Duffy said on November 16 that it remains unclear why a Juniper router installed by L3Harris Technologies in a remote Arkansas facility triggered a nearly five-hour nationwide aviation ground stop, disrupting hundreds of thousands of passengers in the longest in the United States since the September 11, 2001, attacks.
“Based on information provided to our offices from L3 Harris, the copper-to-fiber transition involves converting 3,648 routers to Juniper devices. To date, it is our understanding that 400 devices have been installed, and 69 are operational,” wrote the 13 Democratic senators on the Senate Commerce Committee led by Maria Cantwell.
“With thousands of conversions remaining, FAA must address outstanding safety and reliability concerns before expanding installation,” the senators wrote. “Congress expects clear, fact-based answers about the root cause of this disruption and why existing safeguards failed to prevent it.”
Duffy is set to brief senators on November 17.
The government blamed the mass flight shutdown on the L3Harris router installation.
Hewlett Packard Enterprise, which owns Juniper Networks, did not immediately comment.
L3Harris, which did not immediately comment on November 17, has said it is cooperating with the official investigation into what went wrong.
Duffy said the installation at an FAA radio communications site in El Dorado, Arkansas, led to an overload of a key government communications system at a rate of 1,000 connection attempts every four to five seconds.
That destabilized aircraft communications and radar feeds, affecting 17 of 22 FAA en route air traffic control centers that were using old routers and prompting the ground stop, Duffy said.
The FAA said on November 15 that the initial investigation suggested the data overload could have happened in two locations: the El Dorado site and a radar site in Amarillo, Texas. Duffy said L3Harris replaced the router in Amarillo three weeks earlier.
“Deployment should resume after the FAA demonstrates the devices’ readiness for safe deployment through improved operational testing, independent validation, verified fail over capability, and rollback procedures,” the senators wrote.
Duffy said testing of the two routers was taking place at an L3Harris lab in Florida.
The FAA said that, after the data “inconsistencies” occurred, L3Harris ultimately blocked those two locations, stabilizing the network. The broadcasting function was disabled on the new routers as well as 60 other routers in the system as a precaution.